Vista 15p keypad

All Rights Reserved. Powered by TechWyse. Check the zones which have been indicated for issues, and correct any issues you may see. If you are unsure, please contact our monitoring station. If the problem has been corrected, the display can be cleared if you enter the OFF sequence security code plus OFF key twice.

If the display persists, please contact our service department. If you have wireless sensors, ensure environmental conditions are not an issue and if the problem has been corrected, the display can be cleared if you enter the OFF sequence security code plus OFF key twice.

The minimum delay is 45 seconds. If the delay is between 45 and 96 seconds, then enter the actual seconds. If the delay time is more than 96 seconds, then enter 97 and then the system will give you a delay of seconds.

Note: Both partitions must have a delay time programmed, even if you do not have a 2nd partition. A summary screen will be displayed.

Enter the Zone Type ZT. Refer above or go to page in the Installation and Setup Guide for the exact types. Enter the partition number PT 1 or 2. Report Code RC should be left at The summary will show 10 though this is correct. At this time we will not enter Alpha Descriptors. Then enter 1 when asked to delete zone.

We also recommend adding a resistor to the zone as well. Set to Confirm will be displayed on the screen. This means: Are you installing wireless devices? You will trip the sensor you are entering. If not hit and reenter. The keypad will beep 1 time for confirmation letting you know the code was successfully changed. This can be done from any partition. The keypad will beep 1 time for confirmation letting you know the code was successfully entered.

Using the number pad, enter the hour, then minutes. Press 1 for PM. The following are ways to add keypads to your system. Keep in mind keypads can be addressed 16 to 23 with no duplicates in the addresses. The keypad should come defaulted at 31, but we will default the keypad to make sure everything is correct.

For the second keypad this would be 17, 18 for the third keypad, etc.